Cadillac Cup Holder Coasters 2Pcs Set

$9.99

  • 2 coasters per set — one for each front cup holder
  • 2.75 in (70 mm) across, 0.2 in thick — fits every Cadillac cup holder
  • Soft silicone with a non-slip base
  • Lifts out and rinses clean in seconds
  • Two designs — A with the crest, wordmark and red trim ring, or B with the crest alone
This item is selling fast!

Free worldwide shipping on all orders over $50

  • 30 days easy returns
  • Order yours before 2.30pm for same day dispatch
Guaranteed Safe Checkout

Cadillac Cup Holder Coasters

Cup holders are the worst place in a car to clean. They are deep, narrow, and whatever gets spilled in them dries into a ring at the bottom that no cloth reaches. A silicone insert takes that mess instead — lift it out, rinse it, drop it back in.

Sized for Cadillac Holders

Each coaster is 2.75 inches across and 0.2 inches thick, which sits flat in the standard cup holder used across the Cadillac range. Thin enough that a cup or bottle still seats properly, wide enough to cover the base rather than floating in the middle.

Silicone, Not Rubber

Silicone stays soft in cold weather instead of stiffening, does not go tacky in summer heat, and will not transfer colour into a light-coloured holder the way cheaper rubber inserts can. The textured base grips the holder floor so the coaster does not lift out with your cup.

Two Designs

Design A carries the Cadillac crest with the wordmark below it, framed by a red ring around the outer edge. It is the bolder of the two and reads clearly even with a cup sitting in the holder, since the red border stays visible around the base.

Design B is the crest alone, with no lettering and no coloured border. Cleaner and closer to a factory look, which suits a darker interior or anyone who would rather the detail was noticed than announced.

Both are the same silicone, the same 2.75-inch size, and the same price. The choice is purely how visible you want it to be.

Cleaning

Lift the coaster out, rinse under a tap, and brush off anything stuck. Air dry, or leave it in the sun. Silicone does not hold odour, so a coffee spill does not linger the way it does in the holder itself.

What’s in the Box

Two Cadillac cup holder coasters in your selected design.

 

Frequently Asked Questions — Cadillac Cup Holder Coasters

What is the difference between design A and B? +

Design A has the Cadillac crest with the wordmark beneath it and a red ring around the outer edge. Design B is the crest on its own, with no lettering and no coloured border. Both are identical in material, size and price — A is the bolder look and stays visible around the edge of a seated cup, while B is closer to a factory finish. If you are unsure, B suits a dark interior and A suits anyone who wants the detail noticed.

Will they fit my Cadillac’s cup holders? +

At 2.75 inches across they sit in the standard cup holder used across the Cadillac range. If your car has a wider holder, the coaster still works but will not fully cover the base. Measure the inside diameter of your holder if you want to be certain before ordering.

Will my cup still fit with the coaster in? +

Yes. At 0.2 inches thick the coaster raises the base only slightly, so cups, cans and bottles all seat normally. A tall travel mug that already sits close to the top of the holder will stand a fraction higher, but nothing that affects stability.

Will it lift out when I take my cup? +

The textured base grips the holder floor, so it stays put in normal use. If a wet cup base occasionally suctions to it, press the coaster back down — it seats again immediately and nothing is damaged either way.

Can I put a hot drink on them? +

Yes. Silicone handles the heat of a takeaway coffee without softening or marking, which is part of why it is used here rather than plastic. It also insulates the holder base slightly, so a hot cup does not transfer heat straight into the trim.

How do I clean them? +

Lift the coaster out, rinse under a tap and brush off anything stuck. Air dry or leave it in the sun. Silicone does not absorb odour, so a spilled coffee does not leave a lingering smell the way it does when it dries in the holder itself.

How many do I need? +

Two come in a set, which covers the front cup holders. If your Cadillac has rear holders in the centre armrest or a third row, order a second set to cover those as well.

Is this a genuine GM part? +

No. This is an aftermarket accessory that drops into the existing cup holder. Caddyaccessories is an independent retailer and is not affiliated with, endorsed by, or sponsored by General Motors or Cadillac.

Still have a question? Contact our support team — we reply within 24 hours.

Additional information

Style: No selection

A, B

Reviews

There are no reviews yet.

Be the first to review “Cadillac Cup Holder Coasters 2Pcs Set”